dirty_flasher

Game Over & End Game boards are flashed with the Flipper Zero in USB-UART bridge mode (GPIO -> USB-UART Bridge):

• Baudrate should be set to 115200
• UART pins should be set to 13,14

Game Over & End Game must be in DOWNLOAD mode to flash, you can enter it by:

1. Holding down the BOOT button.
2. While the BOOT button is held, press REBOOT button.
3. Release the BOOT button.

Game Over:

The flasher is not available because your browser does not support Web Serial. Open this page in Google Chrome or Microsoft Edge instead (but not on your iOS device).

End Game:

The flasher is not available because your browser does not support Web Serial. Open this page in Google Chrome or Microsoft Edge instead (but not on your iOS device).

T-Display:

The flasher is not available because your browser does not support Web Serial. Open this page in Google Chrome or Microsoft Edge instead (but not on your iOS device).